GSO OIML D31:2023

Gulf Standard   Current Edition
· Approved on 03 May 2023 ·

General requirements for software controlled measuring instruments

Metrology and measurement in general
Including measuring instruments in general, preferred numbers, standard measures, general aspects of reference materials, etc.

GSO OIML D31:2023 Files

GSO OIML D31:2023 Scope

This International Document specifies the general requirements applicable to legally relevant software-related functionality and security in measuring instruments and gives guidance for verifying the compliance of an instrument with these requirements. This Document shall be taken into consideration by the OIML Technical Committees and Subcommittees as a basis for establishing specific software requirements and procedures in OIML Recommendations applicable to particular categories of measuring instruments (hereafter termed “relevant Recommendations”). The instructions given in this Document apply only to software-controlled measuring instruments or their components. Note 1: This Document does not cover all the technical requirements specific to software-controlled measuring instruments; these requirements are to be given in the relevant Recommendation, e.g. for weighing instruments, water meters, etc. Note 2: This Document addresses some aspects concerning data security. In addition, national regulations for this area need to be considered.

Best Sellers From Metrology Sector

GSO OIML R87:2021
OIML R87:2016 
Gulf Standard
Quantity of product in prepackages
GSO OIML R79:2021
OIML R79:2015 
Gulf Standard
Labeling requirements for prepackages
GSO OIML R121:2007
OIML R 121:1996 
Gulf Standard
The Scale of Relative Humidity of Air Certified Against Saturated Salt Solutions
GSO OIML R 76-1:2009
OIML R 76-1:2006 
Gulf Standard
Non-automatic weighing instruments – Part 1: Metrological and technical requirements - Tests

Recently Published from Metrology Sector

GSO ISO 14405-2:2024
ISO 14405-2:2018 
Gulf Standard
Geometrical product specifications (GPS) — Dimensional tolerancing — Part 2: Dimensions other than linear or angular sizes
GSO ASTM E2847:2024
ASTM E2847:21 
Gulf Standard
Standard Test Method for Calibration and Accuracy Verification of Wideband Infrared Thermometers
GSO ISO 3455:2024
ISO 3455:2021 
Gulf Standard
Hydrometry — Calibration of current-meters in straight open tanks
GSO ISO 12999-2:2024
ISO 12999-2:2020 
Gulf Standard
Acoustics — Determination and application of measurement uncertainties in building acoustics — Part 2: Sound absorption